FRP smoking desulfurization tower

FRP smoking desulfurization tower has a high economic, social and economic benefits. In the industrial boilers and industrial kiln desulfurization dust has a broad prospect. The product from the increase in absorption rate to start, to strengthen the gas-liquid two-phase dynamic function, gas and liquid phase staggered transposition, conducive to the exhaust gas mass transfer process. At the same time also has a small flow resistance, exhaust gas treatment intensity. In addition, the equipment structure is reasonable, easy to operate, easy to use is not easy to plug, covers an area of small advantages, the current treatment of industrial waste, the superiority of the technology ranked wet desulfurization of the first wet.

Technical Parameters

Desulfurization efficiency> 90%; dust removal efficiency> 95%; Lingeman black degree <1; equipment resistance <1600Pa; export wind speed 14-24m / s; gas tower rise speed 4-8 m / s; 0.3 kg;

Specifications Model

Glass fiber flue gas filter specifications 1 ton desulfurization dust collector, 2 tons boiler desulfurization dust collector, 4 tons boiler flue gas desulfurization dust collector, 6 tons boiler flue gas desulfurization dust collector, 8 tons boiler dust collector, 10 tons boiler desulfurization dust collector , 15 tons of boiler desulfurization dust collector, 20 tons of boiler desulfurization dust collector, 25 tons of boiler desulfurization dust collector, 30 tons of boiler flue gas desulfurization dust collector and 30 tons of boiler desulfurization precipitator -410 tons of desulfurization dust collector.

Technical Description

1, handling air volume (Q)

Processing air volume is the amount of dust that can be used to purify the gas in a unit time. Units are cubic meters per cubic meter (m3 / h) or standard cubic meters per hour (Nm3 / h). Is one of the most important factors in the design of bag filter. According to the design of the air flow or the choice of bag filter, the filter can not normally run in the case of more than the provisions of the amount of air, otherwise, the bag is easy to block, shorten the life, pressure loss increased significantly, dust removal efficiency should be reduced; The amount of wind is too large, or increase the equipment investment and land area. Reasonable choice of handling air volume is often based on process conditions and experience to decide.

2, the use of temperature

For the bag filter, the use of temperature depends on two factors, the first is the maximum temperature of the filter material, the second is the gas temperature must be above the dew point temperature. At present, due to the large selection of glass fiber filter, the maximum temperature of up to 280 ℃, higher than the temperature of the gas must take measures to reduce the temperature below the dew point of the gas must take measures to increase the temperature. Now with the PPS filter more temperature of 170. For the bag filter, the use of temperature and dust removal efficiency is not obvious, which is different from the electrostatic precipitator, the electrostatic precipitator, the temperature changes will Affect the specific resistance of dust and other dust removal efficiency.

3, the entrance dust concentration
That is, the inlet dust concentration, which is determined by the dust point of the process, in the design or selection of bag filter, it is second only to deal with the air volume is another important factor. Expressed in g / m3 or g / Nm3.
FRP smoking desulfurization tower has a high economic, social and economic benefits. In the industrial boilers and industrial kiln desulfurization dust has a broad prospect. 
top