FRP Centrifugal Fan

FRP Centrifugal Fan As the name suggests is a shell with fiberglass anti-corrosion material manufacturing centrifugal fan, the working principle is when the motor rotation to drive the fan wheel rotation, the impeller between the leaves of the gas also followed the rotation, and centrifugal force in the role of throwing these Gas, gas flow rate increases, so that the gas in the flow of kinetic energy into static pressure energy, and then with the pressurization of the fluid, so that static pressure can be converted to the speed of energy through the exhaust port of gas, and in the middle of the impeller A certain negative pressure, due to the negative pressure at the entrance, so that the external gas under the action of atmospheric pressure immediately fill in the continuous rotation of the impeller under the continuous discharge and fill the gas, so as to achieve the purpose of continuous blast. The same power, the wind pressure and air flow in general contrary. The same power, the wind pressure, the air volume will be relatively low, and the air volume, the wind pressure will be lower, so as to make full use of the motor efficiency.

General fiberglass centrifugal fan can be used in the case of corrosive gases, emissions of corrosive gases. The gas is not allowed to contain the viscous material, containing dust and hard particles less than or equal to 150mg / m3, gas temperature is less than or equal to 60 degrees, relative humidity less than or equal to 100%. High temperature places are not suitable for use with glass fiber reinforced plastic centrifugal fans.

Widely used in chemical, electroplating, oxidation, power plants, laboratories, circuit boards, environmental protection equipment containing corrosive gases occasions.

FRP Centrifugal Fan
top